Working with the results table, Result table – Teledyne LeCroy ENETbusD Decoder User Manual
Page 11
Instruction Manual
922665 Rev A
9
Frame Length Error
Preamble Value Error
SDF Value Error
CRC Error
Data Size Error
Unknown - Next occurrence of an unknown frame type.
Working with the Results Table
By default, a table summarizing the decoder results appears below the grids whenever a decoder is
enabled. The decode result table provides a view of message data as decoded by the oscilloscope during
the most recent acquisition, even when messages are too compact to allow annotation on the waveform
trace.
The table is displayed only when the View Decode checkbox is marked on the Decode Setup Dialog and
a source signal has been decoded using that protocol.
You can
, changing both the number of rows and the columns displayed. The
default is one row. A scrollbar at the right of the table lets you display the previous or next row of table
data.
On a single-row table, touch the Down arrow to open the scrollbar.
to a .CSV file, and the table itself provides a useful tool for