Teledyne LeCroy CANbus TD - Quick Reference Guide - Manual (Page 2)

CANbus TD is a Trigger
and Decoding tool that
will greatly increase
your ability to debug
and analyze embedded
controllers that use
CAN Bus communications,
or entire systems
consisting of multiple
CAN controllers.
The names of the
hardware components
in CANbus TD are listed
at the right.
Connecting the CANbus TD hardware
to your LeCroy oscilloscope is easy.
Follow these simple steps:
1 Connect the USB cable to one
of the oscilloscope’s USB ports
2 Connect the other end of the
USB2.0 Cable to the CANbus TD
Trigger Module.
3 Connect the CANbus TD
Oscilloscope Interface Module
(OIM) to the EXT input of
the oscilloscope.
4 Connect the 3-pin plug end
of the OIM to the Trigger Module.
1
First Steps
1 2
3 4
CAN Low Speed
and Single-Wire
Connection Cable
CAN High-speed
Connection Cable
Trigger Module
120 Ω
Terminations
Oscilloscope
Interface
Module (OIM)
USB 2.0 Cable