Teledyne LeCroy PP011 - Manual (Page 14)

PP011 Passive Probe
12 922224-00 Rev A
Tip Selection and Exchange
The PP011 probe is supplied with two tip styles. The spring tip, which is installed
when the probe is shipped, combines a sharp point with on-axis compliance. This
provides reliable connection under a wide range of physical interconnect
situtations. A rigid tip is also supplied. While lacking the on-axis compliance
feature of the spring tip, the rigid tip has a larger diameter and is more robust
when exposed to physical stress at the tip. Select the proper tip for your
application needs.
To change the tip or replace it when damaged, carefully grip the outer most
portion of tip and pull straight out, along the axis of the probe, using needle
nose pliers. Do not attempt to grip the plastic insulator with pliers when
removing the tip, as this will squeeze the tip, which will make it difficult or
impossible to remove. Do not grip the outer gold plated tube which the tip slides
into. With the tip removed, align the replacement tip with the hole and begin
the insertion with the pliers. To fully seat the tip, placie the probe against a hard
surface and gently apply pressure.
To remove tip, grip the spring-loaded
portion of the tip beyond the outer sleeve
and pull straight out.
Do not apply pliers to the plastic insulator.