Teledyne LeCroy OE5x5 - Manual

922263-00 Rev A
Specifications OE425/525 OE455/555
Wavelength Range
500 –870 nm /
460 –870 nm (0.1 V/mW)
950 –1630 nm /
800 –1630 nm (0.1 V/mW)
Conversion Gain 0.5 V/mW 1.1 V/mW
Bandwidth 4.5 GHz (6 GHz optical) 3.5 GHz (4.5 GHz optical)
Equivalent Noise 2.2 μW rms 1.0 μW rms
Maximum Optical Power
(at 5% saturation)
2.2 mW 1.0 mW
Rise Time (typical) 90 ps 108 ps
Maximum Safe Input 5.5 mW 2.5 mW
Temperature Drift 0.00275 dB/deg. C
Frequency Response Ripple 1.1 dB
Connector Type FC/PC
Temperature (Operating) 5 °C to 40 °C
Temperature (Storage) -20 °C to 60 °C
Humidity (Operating): 5% to 80% RH (non-condensing), 50% RH above 30 °C
Humidity (Storage)
5% to 95% RH* (non-condensing)
* 75% RH above 30 °C and 45% RH above 40 °C
Certifications Conforms to EN61010-031/A1:2008 (Safety) and EN61326-1:2006 (EMC)
CAUTION. Use only within operational environment listed. Do not remove probe casing.
Observe all terminal ratings. Use product only as specified.
Calibration
The recommended calibration interval is one year. Calibration should be performed by qualified
personnel only.
Cleaning
Clean only the exterior of the converter with a soft cloth moistened with water or 75% isopropyl
alcohol solution. Under no circumstances should moisture be allowed to penetrate the converter.
The fiber connectors can be cleaned by blowing residue-free air into the connector to remove loose
particles.
CAUTION. T he converter’s fiber connectors should be mated only to other well cleaned
connectors.
© 2013 Teledyne LeCroy, Inc. All rights reserved.
Unauthorized duplication of Teledyne LeCroy documentation materials other than for internal sales and distribution
purposes is strictly prohibited. Teledyne LeCroy, WavePro, and WaveMaster are registered trademark of Teledyne
LeCroy, Inc Information in this publication supersedes all earlier versions. Specifications are subject to change
without notice.
Operator’s
Manual
OE4x5 / OE5x5
Optical-to-Electrical Converters