En en, Freezing, Defrosting of the device – Teka NFE2 400 User Manual
Page 12
6
Freezing
Freezing food
The freezing area is marked with
symbol.
You can use the appliance for freezing fresh
food as well as for storing pre-frozen food
Please refer to the recommendations given on
the packaging of your food.
Attention
Do not freeze fizzy drinks, as the bottle may
burst when the liquid in it is frozen.
Be careful with frozen products such as
coloured ice-cubes.
Do not exceed the freezing capacity of your
appliance in 24 hours. See Technical
Features leaflet.
In order to maintain the quality of the food, the
freezing must be effected as rapidly as
possible.
Thus, the freezing capacity will not be
exceeded, and the temperature inside the
freezer will not rise.
Attention
Keep the already deep-frozen food always
separated with freshly placed food.
When deep-freezing hot food, the cooling
compressor will work until the food is
completely frozen. This can temporarily cause
excessive cooling of the refrigeration
compartment.
If you find the freezer door difficult to open just
after you have closed it, don’t worry. This is
due to the pressure difference which will
equalize and allow the door to open normally
after a few minutes.
You will hear a vacuum sound just after
closing the door. This is quite normal.
Making ice cubes
Fill the ice-cube tray 3/4 full with water and
place it in the freezer.
As soon as the water has turned into ice, you
can take out the ice cubes.
Never use sharp objects such as knives or
forks to remove the ice cubes. There is a risk
of injury!
Let the ice cubes slightly thaw instead, or put
the bottom of the tray in water for a short
moment.
Defrosting of the device
The appliance is a frost free refrigerator.
So there will not be any frost accumulation
inside the food storage area.
However there will be an automatic defrost at
the evaporation area of the appliance when it
needs. The water drams into reservoir at the
back of the appliance and evaporates
automatically through the compressor heat
(Fig. 8).
Ensure that the reservoir is fixed properly
above the compressor.
en en