American Power Conversion Airless Paint Sprayer 68001 - Manual (Page 18)

Page 18 For technical questions, please call 1-800-444-3353. SKU 68001
Notice
Clean the Sprayer ImmedIAtely after use. delayed or inadequate cleaning will permanently clog the
Spray Gun. Warranty void if sprayer is not properly cleaned immediately after every use.
long term Storage
When cleaning for long term storage (more than 48 hours).
It is very important that the Paint Sprayer is not stored
with any water or water-based material left in the Pump,
Hose, Tubes, or Spray Gun. This will corrode the product.
1. Clean the Sprayer before storage.
See “Cleaning” on pages 16-17.
2. Remove paint hose if not already removed.
3. Turn the unit over and loosen the Clamps from both
Tubes, then disconnect them from the Pump Body.
4. Add one ounce of light household oil into each inlet.
5.
Hi Spray Low Spray Prime/Clean Roll
Turn Prime/Spray switch to Spray.
6. Hold a rag over the paint hose outlet.
7. Switch Power to ON for five seconds,
then turn the power OFF.
8.
Hi Spray Low Spray Prime/Clean Roll
Turn Prime/Spray switch to Prime,
this will keep storage fluids in sprayer.
9. Replace the Tubes and secure with the Clamps.
10. Wipe the sprayer with a clean cloth. Store in a
clean dry location out of reach of children.