Autodesk Z800 - Manual (Page 46)

Value Item Submenu BIOS Menu
USB Device
Hard Drive
Integrated SATA
Disable Runtime Power Management OS Power Management Power
Normal Idle Power Saving
Disable MWAIT Aware OS
Disable ACPI S3 Hard Disk Reset
Disable SATA Power Management Hardware Power Management
Disable Intel Turbo Boost Technology
Enable Hyper-Threading Processors Advanced
Enable Memory Node Interleave Chipset/Memory
Disable NUMA Split Mode
Disable S5 Wake on LAN Device Options
Disable Internal Speaker
Disable NIC PXE Option ROM Download
Disable Option ROM Download Slot 1 PCIe2 x8(4)
Disable Option ROM Download Slot 3 PCIe2 x8(4)
Disable Option ROM Download Slot 4 PCIe2 x16(8)
Disable Option ROM Download Slot 6 PCI32
Updating your System BIOS
The BIOS version installed on your system appears on the screen while booting the workstation. The following
procedure describes how to update a workstation to the certified BIOS version required by your application.
NOTE Before attempting to update the system BIOS, make sure the SATA Emulation option is properly set,
otherwise your optical drive is not detected.
To update the BIOS on your workstation:
1 Download the latest version of the DKU from Autodesk and extract the tar file into a temporary directory.
2 Go to the /Utils/BIOS subdirectory of the DKU directory.
In the BIOS directory there is a subdirectory for each platform supported by the current version of your
Visual Effects, Finishing, and Colour Grading application.
3 Go to the directory that corresponds to your hardware platform.
42 | Chapter 7 Configuring the Workstation BIOS