Superwinch DC POWER DRIVES - Manual (Page 7)

7
E L E C T R I C A L C O N N E C T I O N – D C U N I T S, (
.CONT.)
This section applies to the electrical connections of the DC Power
Drives only.
CONNECTIONS
Electrical connection is made via the two 1/4-20 UNC studs on the end of the
motor (see Figure 2 on page 3). Hold the inner nut with a wrench when
tightening the outer nut. Torgue the outer nut to 21-26 lb. in.
Step (1) Disconnect the battery "negative" terminal connection.
Step (2) Check motor terminals against Figure 2 for identification.
Step (3) Connect stud 1 to the positive terminal and stud 2 to the negative
terminal. This will cause the gearbox output shaft to rotate in a clockwise
direction as viewed from the mounting side. Reversing the connections will
reverse the direction of rotation.