Accusplit AE1640M4 - Manual (Page 2)

MEMORIES
This pedometer has memories to keep track of your activity
data for today, this week, and last week. The unit stores
your steps, distance, calories, and activity time data for
each of these time periods. It can also display your daily
averages of these measures for the previous week.
To view today’s data, press the aqua DAY.CUM button until
a bar appears underneath the DAY indicator in top right
hand corner of display. Now, repeatedly press the yellow
MODE button to view steps, distance, calorie, and activity
time values for the day.
To view this week’s total data, press the aqua DAY.CUM
button until a bar appears underneath the CUM indicator in
top right hand corner of display. Now, repeatedly press the
yellow MODE button to view steps, distance, calorie, and
activity time values accumulated so far this week.
To view the previous week’s data, you must start from
the steps, distance, calories, or activity timer mode. Press
the cream MEMORY (WK-AVG) button until a bar appears
underneath the WEEK indicator in the top right hand
corner of display, and the indication “TL” (for Total)
appears on the left hand side of the display. The day of
the week indicators will all start to flash. Now, repeatedly
press the yellow MODE button to view the TOTAL steps,
distance, calorie, and activity time values for last week.
Press the cream MEMORY button once more to view the
DAILY AVERAGE of steps, distance, calories, and activity
time for last week. The indicator on the left hand side
of display will change to say “Avg” (for AVERAGE). To
exit back to today’s or this week’s data, press the cream
MEMORY button one more time.
REGISTER NOW Please return
your AE1640M4 Registration to
the Repair Center address in the
warranty, and we will let you know
about future products.
Email (preferred)
User
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label inside the lid of your pedometer
AUTO MOVEMENT SENSOR
1. To filter out random movements, the unit remains in
standby mode until 5 continuous steps are registered.
Only then are the 5 steps calculated in, and an Active
indicator “▲” appears on the upper left of display.
2. When regular walk/run movement stops, after 2 seconds
the timer pauses and the unit switches to standby status
(Active indicator “▲” disappears).
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset: While
displaying Day’s STEPs, DISTANCE, or ACTIVITY TIME, press and
hold yellow RESET button for at least two seconds to reset all of
these to zero. When displaying Total STEPs, press aqua RESET
button for two seconds to reset all counts, including Total STEPS,
to zero.
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to replace
the battery. Your pedometer uses one Type LR43 (L1142) 1.5 volt
alkaline battery. To replace:
1. Insert a coin into the slot on the bottom of the case, and twist
counterclockwise to loosen the case front. Lift case front away.
2. Using a pen or other thin object, push battery sideways out
of its holder. Replace it with a new battery. The battery’s
positive (+) terminal should be FACE UP while you put it into
the pedometer.
3. Align case front over the pedometer and press gently to snap
cover back into place, starting with top.