AT&T 5870 - Manual (Page 39)

36
Blind Call Transfer
If you have installed additional AT&T 5800 handsets
(purchased separately) with your 5870 telephone, you can
transfer a call from one handset to another.
From the Handset
1 Press , then use to highlight
where you want the call transferred.
2 Press when the desired destination
is highlighted to complete the transfer.
From the Base
1 Press . .
2 Press the number of the handset where you
want the call transferred (for example, 2).
NOTE: An unanswered call will ring back to the
originating handset or base if not answered in 30
seconds. If the originating handset or base does not
answer the unanswered call yet, the call will end
automatically in 30 seconds.
Announced Call Transfer
From the Handset
1 Press to put the call on hold.
2 Press , then use to highlight
INTERCOM.
3 Press , then use to highlight the
call destination, then press again.
4 When the handset or base answers, announce
the caller.
5 Press on the handset or
K on the
base to end the call.
6 Press
P on the receiving handset or
K on the base to pick up the call on
hold.
From the Base
1 Press
H to put the call on hold.
2 Press , then press the number(1~6) of
the handset you want to reach.
3 When the handset anwsers, announce the caller.
4 Press
O on the handset or K on the
base to end the call.
5 Press
P on the receiving handset to pick up
the call on hold.
OK
OK
MENU
HOLD
OK
XFER
M M M
M M M S S S
N N N R R R
L L L L L
M M M
M M M
INTERCOM OPERA
TION
INTERCOM OPERA
TION
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 35