Staub Electronics WPS-700-BUL-A WIREPATH - TRUE DAY_NIGHT OUTDOOR VARIFOCAL BULLET CAMERA (600 TVL, D-WDR) - Manual (Page 24)

24
WPS-500-BUL-A Installation Manual
The color of the picture is not correct
• Check White Balance and Color (Red / Blue) settings.
• Reset the camera to factory default settings
Screen flickers continuously
• Check the camera location to make sure it is not pointing
directly towards the sun or bright light source
• Check if the flickerless control is set correctly; proper settings
should reflect required refresh rates.
• Reset the camera to factory default settings
AGC settings are not available
• DAY&NIGHT Mode is set to AUTO. To enable AGC control
change DAY&NIGHT to EXT, Color or B/W
RS-485 communication failure
• Check whether the RS-485 polarity is connected correctly to
the RS-485 port.
• Check the Camera ID setting and make sure there is not
more than one device with the same ID on the RS485 network.
• Check the Protocol and Baud Rate for all devices are set
to the same configuration.
• Warning: Conflicting settings of the protocol and Baud Rate
among devices connected to the RS485 network could result
in abnormal operation of the camera. Ensure that the Pro-
tocol and
Baud Rate for all devices are set to the same configuration.
OSD Menu appears randomly without prompt from user
• Check the Pigtail - Verify that the pigtail is not pinched.
• Secure RS485 Wiring - Verify that the RS485 wires are not touching or
shorting on a metal box.
Condensation Appears on Camera Lens Cover
• Check the color of the beads in the Silica pack under the lens cover.
• If the blue crystals have turned pink indicating that the pack has
absorbed moisture, replace the pack with the spare provided with
the camera.