Luxor|H.Wilson WPS5CE - Manual (Page 3)

Page 3
Back Panel
Bottom Panel
Left Side
4. Lay left side panel (#2) flat on floor. Take back panel (#4)
and place camlocks into pre-drilled holes. Fit holes in back
panel over shoulder screws so the camlocks are inside.
Tighten camlocks. Insert camlocks into bottom shelf (#3).
Place bottom shelf pre-drilled holes over the shoulder screws
in left side so that the front edge is recessed approximately
1/2" from the front of the side panel - camlocks will be on
the underside of the shelf. Tighten camlocks.
5. Place Keyboard
Door (#11) over
Metal dowel pin
on left side panel.
(Photo shows hole
and pin, it will be
upright 90° angle,
flush with edge.
6. Place predrilled hole
in upper brace (#10) over
shoulder screw in left side
panel. (Upper brace has
wood dowels factory
installed. Put included glue
on dowell before putting in
Hole.) Tighten camlock.
7. Line hardware on right
side up with the predrilled
holes in the keyboard door,
upper brace, bottom and
back panels. Fit together
and tighten all camlocks.
Keyboard Door
Metal Dowel Pin
Left Side
(Right Side
Not Shown)
Upper Brace
Right Side
Upper Brace
Keyboard Door
Bottom
Back
Left Side
2 People Should
Assemble This Product!
Keyboard Rail
Camlocks
Camlocks go in
the underside of
the bottom shelf
***Make suree the side of the camlock that you can put a
screwdriver in is facing outward.
Bottom Panel is recessed ½"
not flush with edge of left &
right panels