beautypg.com

Luxor|H.Wilson OHS42 User Manual

Page 4

background image

4.

Slide runners onto the legs and tighten down to desired height. Align

holes on the shelf adapters to the holes on the bottom of the keyboard

and attach using six sheet metal screws. Slide the rear of the shelf

adapters under the tab on the back of the runners and snap the front of

the shelf adapters onto the back tongue on the front of runners.

IMPORTANT:

Electric Assembly should

be assembled first.

Align cord bracket to the pre-drilled holes on the underside

of the middle and attach using two silver screws.

5.

Insert the leg post on the top shelf into the smaller legs.

TAB

SHELF RUNNER

ADAPTER

ELECTRIC ASSEMBLY

SCREWS

LOCKING TONGUE

Allen head set

screw & wrench

Set shelf height as

desired then tighten

Allen head set

screws to secure

Allen head set

screw & wrench

Allen head set

screw & wrench

2

With bottom shelf facing up push all four 18” legs
onto leg posts. Using rubber mallet hammer legs
firmly into position. Legs must be seated (flush)
against the shelf surface. Place rubber band
around legs to aid in the assembly of cabinet
side panels and doors.

3

Install the side panels first. Slide panels down
between legs until they are nested inside the
shelf lip and flush against the shelf surface.
Rubber band will hold legs and side panels in
place while installing back panel and front door.

4

Install the back panel in the same manner as
shown in Step #3. NOTE: Cabling hole in back
panel should be toward the top.

5

Install door panel same as back panel, with
door handle at top.

18” LEG

RUBBER BAND

BOTTOM

SHELF

LEG POST

SIDE

PANEL

SIDE VIEW WITH

PANEL SEATED

INSIDE SHELF LIP

LEGS

TOP VIEW

6

Begin seating of center shelf by holding door panel,
leg and side panel as illustrated. Gently tap corner
post into leg. Repeat on all 4 sides until all posts
are partially inserted into legs. Now repeat ham-
mering action more firmly going around to each
shelf post and driving the leg posts more securely
into the legs.
Top of panels and door frame must be nested into
the underside of the center shelf lip in the same
manner as the bottom shelf.

CENTER

SHELF