LevelOne HVE-6601T User Manual
Page 17
8. Once user complete the 3 steps of
“Basic Setup”, a basic video wall
configuration is done.
Step 1: Choose Wall Size.
a.
Set
“Vertical Monitor Count” to 3.
b.
Set
“Horizontal Monitor Count” to 3.
c.
Press
“Apply” button.
d.
User will notice that all screens will refresh. If
any row doesn’t
response, check the connection of RS232 chain and retry.
Step 2: Setup Column Position for Each Display.
a.
A OSD of a screen will shows up. User now starts to assign the
column position of each client. If OSD
doesn’t show up, try to
switch back to step 1 and then step 2 again.
b.
There are 3 buttons in this step:
i.
“Next in Column” and “Next in Row” are used to select the client
to be controlled. The chosen client will show up OSD.
ii.
“Change Column” is used to configure the column of the chosen
client.
Step 3: Bezel and Gap Compensation.