LevelOne WAP-6150 - Manual (Page 41)

41
CHAPTOR 4 Troubleshooting
This Chapter provides solutions to problems for the installation and operation of the WiFi
Concurrent N600 Business AP. You can refer to the following if you are having problems.
1
Why can’t I configure the router even the cable is plugged
and the LED is lit?
Do a Ping test to make sure that the WiFi
Broadband Router is responding.
Go to Start > Run.
1. Type cmd.
2. Press OK.
3. Type ipconfig to get the IP of default gateway.
4. Type “ping 192.168.1.1”. Assure that you ping the correct IP Address
assigned to the WiFi Concurrent N600 Business AP. It will show four replies if
you ping correctly.
Ensure that your Ethernet Adapter is working, and that all network drivers are installed
Note: It is recommended that you
use an Ethernet connection to
configure it