LevelOne WAP-6101 - Manual (Page 45)

WPA-6101 300Mbps Wireless Ceiling Gigabit PoE Access Point
Due to Limited environment, End-user uses Universal Repeater to extend Network
access . For example:
1.Add AP2 ,AP3,AP4 to deploy
2.Switch AP2 ,AP3 and AP4 as Slave Mode via WEC Button
3.Click WEC Button of master AP1 and slave AP2 as one pair simultaneously
4.Click WEC Button to sync “Slave AP2 ,slave AP3”
and ““Slave AP3 ,slave AP4” ”as one pair.
5.Se
tup “Extend Wireless” in sequence as follows: AP1AP2AP3AP4
※If AP3 is removed, just Click WEC Button to sync “Slave AP2 ,slave AP4” as one
pair.
Appendix A. Licensing information
This product includes copyrighted third-party software licensed under the terms of the GNU General Public
License. Please refer to the GNU General Public License below to check the detailed terms of this license.
The following parts of this product are subject to the GNU GPL, and those software packages are copyright
by their respective authors.
Linux Kernel GPLv2 Linux-2.6.21
busybox GPLv2 busybox_1.3.2
bridge-utils GPLv2 bridge-utils 1.1
udhcp server GPLv2 udhcp-0.9.9