LevelOne FSW-1671 - Manual (Page 40)

36
Logout
It will logout from User Interface when you press the it.
Load default Setting –hardware based
The purpose of this function is to provide a method for the network administrator to
restore all configurations to the default value.
(1) To activate this function, the user should follow the following procedures. Press the
“Load default” button for 3 seconds until you see the LED blinking.
(2) When LED starts blinking, it means the CPU is executing the “load default”
procedure. You can release the button now.
After completing this procedure, all the factory default value will be restored. It
includes the IP address, the user name, the password and all switch configurations.