LevelOne WBR-3470 - Manual (Page 55)

incoming packets.
Active: Choose “Yes” to enable the rule, or choose “No” to disable the rule.
Packet Type: Specify the packet type (TCP, UDP, ICMP or any) that the rule applies to.
Select TCP if you wish to search for the connection-based application service on the remote
server using the port number. Or select UDP if you want to search for the connectionless
application service on the remote server using the port number.
Log: Choose “Yes” if you wish to generate logs when the filer rule is applied to a packet.
Action When Matched: If a packet matches this filter rule, Forward or Drop this packet.
Source IP Address: Enter the incoming or outgoing packet’s source IP address(es).
Source Port: Check the TCP or UDP packet’s source port number(s).
Destination IP Address: Enter the incoming or outgoing packet’s destination IP
address(es).
Destination Port: Check the TCP or UDP packet’s destination port number(s).
Schedule time: User can setup the time to use the packet filter.
If the DHCP server option is enabled, you must be very careful in assigning
IP addresses of a filtered private IP range to avoid conflicts because you do
not know which PC in the LAN is assigned which IP address. The easiest
and safest way is that the filtered IP address is assigned to a specific PC
that is not allowed to access an outside resource such as the Internet. You
configure the filtered IP address manually for this PC, but it stays in the
same subnet with the router.
Attention
53