Asus A7V - Manual (Page 34)

34 ASUS A7V User’s Manual
Connectors
3. H/W SETUP
3. HARDWARE SETUP
9) Primary (Blue) / Secondary IDE Connectors
(40-1 pin PRIMARY IDE/SECONDARY IDE)
(40-1 pin PRIMARY ATA100/SECONDARY ATA100)
These connectors support the provided IDE hard disk ribbon cables. Connect
the cable’s blue connector to the motherboard’s primary (recommended) or sec-
ondary IDE connector, and then connect the corresponding gray connector to
your UltraDMA/100 / UltraDMA/66 slave device (hard disk drive) and the black
connector to your UltraDMA/100 / UltraDMA/66 master device. It is recom-
mended that non-UltraDMA/100 / Ultra/66 devices be connected to the second-
ary IDE connector.
NOTE: UltraDMA/100 is backward compatible with DMA/66, DMA/33, and
DMA and with existing DMA devices and systems so there is no need to upgrade
current EIDE/IDE drives and host systems.
If you install two hard disks, you must configure the second drive to Slave mode
by setting its jumper accordingly. Refer to your hard disk documentation for the
jumper settings. BIOS now supports specific device bootup (see 4.6 Boot Menu).
(Pin 20 is removed to prevent inserting in the wrong orientation when using
ribbon cables with pin 20 plugged). If you have more than two UltraDMA/100
/ UltraDMA/66 devices, you will need to purchase another UltraDMA/100 /
UltraDMA/66 cable.
NOTE: The hole near the blue connector on the UltraDMA/100 / UltraDMA/66
cable is intentional.
TIP: You may configure two hard disks to be both Masters with two ribbon
cables – one for the primary IDE connector and another for the secondary IDE
connector. You may install one operating system on an IDE drive and another on
a SCSI drive and select the boot disk through 4.6 Boot Menu.
A7V IDE Connectors
01 01 01
A7V
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
Primary Ultra
A
T
A100 IDE Connector
Secondary Ultra
A
T
A100 IDE Connector
PIN 1
Primary IDE Connector Secondary IDE Connector
PIN 1
IMPORTANT: UltraDMA/66 and UltraDMA/100 IDE devices require a 40-pin
80-conductor cable to be enabled.