King Electric WR Window Watcher - Manual (Page 3)

WRP230 WRP230
WINDOW WATCHER WINDOW WATCHER
™ PROGRAMMING INSTRUCTIONS
ENERGY STAR
SAVE THESE INSTRUCTIONS
1 Comfort and Economy Setting Comfort and Economy Setting
WRP programming.ai : 12/09
START MO 1
SU 7 TU 2
SA 6 WE 3
FR 5 TH 4
Reset
START MO 1
SU 7 TU 2
SA 6 WE 3
FR 5 TH 4
Reset
Turn rotary switch to START.
To adjust setup (comfort) and setback (economy)
temperatures.
1
2
Press twice to enter room temperature
“HI” (comfort) setpoint. Press or to adjust.
Press to exit.
4
Wait 5 seconds after adjusting the temperature. The thermostat shall
memorize setting and return to the main screen.
Press or to alter the setting between
and on the LCD display.
Press or to select each individual time schedule. Each time schedule
will be indicated by flashing symbols.
3
1
2
4
Turn indicator on rotary switch to the desired week day to
begin programming time.
After setting all 7 days of the week turn rotary switch to “START”. The
thermostat will now start to operate its program.
3 Independent Daily Time Schedule Setting Independent Daily Time Schedule Setting
2 Clock Clock
3
Press twice to enter room temperature
“LO” (economy) setpoint. Press or to adjust. Press to exit.
This thermostat has only two air temperature settings: 7 independent days
and 30 minute increments. Users can adjust Comfort and Economy
time to their schedule many times per day.
If the dial is left in anything but the START position it will default to “ERR”
(Error). Turn to START to clear Error and restart programming.
Factory default settings are 70°F/21°C and 61°F/16°C .
START MO 1
SU 7 TU 2
SA 6 WE 3
FR 5 TH 4
Reset
Press or to select the day of the week.
3
1
2
5
Turn indicator on rotary switch to “START”.
Repeat pressing and to finishing setting the time.
6
LCD display shall automatically memorize the setting and return to the main
screen 5 seconds after time is set.
Press to enter clock programming.
5 Manual (Temporary Override) Manual (Temporary Override)
5
Window Watcher Window Watcher
™ mode mode
START MO 1
SU 7 TU 2
SA 6 WE 3
FR 5 TH 4
Reset
Press or to adjust temperature setting.
3
1
2
4
Turn indicator on rotary switch to “START”.
The LCD display will flash for approximately 8 seconds after temperature setting
is complete then return to the main LCD display screen. The thermostat will now
begin to execute the Manual function.
5
Turn the rotary switch away from “START” then turn it back to “START” to
terminate the Manual function.
Press or to indicate current or
temperature settings.
When in Comfort while setting the Manual function the thermostat will
maintain executing Manual until the program runs to Economy .
The same is true in Economy .
The and icons will disappear from the LCD at the section of time the
Manual function is operating.
4
Press again to adjust hour of day.
4 Hold Hold
Press “HOLD” for constant temperature.
Any remote contacts can be used to activate the 40° set back. Multiple contacts
can be placed in series so that if any break in the small 22 gauge control wire
is sensed the thermostat will display “OFF” on the LCD window. As soon as the
window contacts are closed the thermostat will resume operating like normal (the
previous setting before the contacts were opened).
5 Motion Detecting Motion Detecting
Optional motion detecting can set back to 40°F (or to a higher 60°F) if required.
PATENT APPLIED FOR
In 40° set back mode
(window open)