King Electric SRK12 end-seal kit - Manual (Page 2)

Push back the braid and cut 3/4” off
the end of the cable..
Apply heat evenly until the cap shrinks
around the cable. 4 5
Pull the braid back over the end cap and
twist the braid end together.
6
Slide the 4” woven braid sleeve
over the cable, allowing 1/2” to
extend past the end.
7 Slide the 5 ” heat shrink tube over the
woven braid, allowing it to extend 1/2 ”
past the end of the woven sleeve just
applied.
8
Apply heat evenly to the heat shrink
tube unit it shrinks around the cable
9
While the shrink tubing is still hot,
gently squeeze the end with pliers
and hold it until it has cooled. The end must remain sealed after
the pliers are removed. If the tube
does not remain sealed, then repeat
steps 7 and 8.
11 12
Push back the braid and slide the heat
shrink cap over the end of the cable..
10
King Electrical Mfg. Company will repair or replace, without charge to the original owner, any heating cable found to be defective or malfunctioning within the 2 year warranty.
In Case of Product Failure: Contact King Electrical Mfg. Co. at 800.603.5464. The owner will be required to provide, within the designated warranty period, the following
information: model number, date of purchase, and a complete description of the problem encountered with product. Upon receipt of the aforementioned, the company will
reply to the owner within a period not to exceed fifteen (15) working days, and will provide the action to be taken by owner. Terms: This warranty requires the owner or his
agent install the equipment in accordance with the National Electrical Code, any other applicable heating or electrical codes and the manufacturer's installation instructions. It
further requires that reasonable and necessary maintenance be performed on the unit. Failure of proper maintenance by owner will void the warranty in its entirety. The
company is not liable for any actions it deems to be abuse or misuse of the product. The customer shall be responsible for all costs incurred in the removal or reinstallation of
products, including, but not limited to, labor costs, and shipping costs incurred to return products to King Manufacturing. At their discretion, King Manufacturing will decide to
either repair or replace the product, with no charge to the owner, with return freight paid by King. The Company shall not be liable for consequential damages arising with
respect to the product, whether based upon negligence, tort, strict liability or contract. No other written or oral warranty applies, nor any warranties by Representatives,
Dealers, Employees of King or any other person. King Manufacturing can be contacted by phone at 206.762.0400, fax 206.763.7738 or website www.king
‐electric.com.The
company's minimum liability shall not in any case exceed the list price for the product claimed to be defective.
Warranty Information:
www.king-electric.com Rev. 8.13.12 Telephone: 206-762-0400 pg2