American Dryer Corp. T20 User Manual
Page 3
113428-9
Telephone 01422 822282
3
IMPORTANT
You must disconnect and lockout the electric
supply and the gas supply or the steam supply
before any covers or guards are removed from
the machine to allow access for cleaning,
adjusting, installation, or testing of any
equipment per OSHA standards.
Please observe all safety precautions displayed
on the equipment and/or specified in the
installation manual included with the dryer.
Before installation, check that the local
distribution conditions, nature of gas and
pressure, and adjustment of the appliances are
compatible.
CAUTION
Dryer(s) should never be left unattended while
in operation.
“Caution: Label all wires prior to disconnection
when servicing controls. Wiring errors can
cause improper operation.”
«Attention: Lor des opérations d’entretien des
commandes étiqueter tous fils avant de les
déconnecter. Toute erreur de câblage peut étre
une source de danger et de panne.»
WARNING
Children should not be allowed to play on or
near the dryer(s). Children should be supervised
if near dryer(s) in operation.
Under no circumstances should the dryer door
switch(es), lint door/drawer switch(es), or heat
safety circuit(s) ever be disabled.
The dryer must never be operated with any of
the back guards, outer tops, or service panels
removed. Personal injury or fire could result.
The dryer must never be operated without the
lint filter/screen in place, even if an external lint
collection system is used.
FOR YOUR SAFETY
Do not dry mop heads in the dryer. Do not
use dryer in the presence of dry cleaning
fumes.
The dryers must not be installed or stored in an
area where it will be exposed to water
and/or weather.
The wiring diagram for the dryer is located
behind the control panel.
Table of Contents_________
List of Acronyms __________________________
HVAC Heating, Ventilating, and Air-Conditioning
in WC Inches of Water Column
L.C.D. Liquid Crystal Display
L.E.D. Light Emitting Diode
L.P.
Liquid Propane
OSHA Occupational Safety and Health Administration
UL
Underwriters Laboratory
Safety Precautions ................................. 4
T20 Stack Specifications ....................... 6
T30 Stack Specifications ....................... 8
Installation Procedures........................ 10
Location Requirements ........................................ 10
Unpacking/Setting Up .......................................... 10
Dryer Enclosure Requirements ............................ 10
Fresh Air Supply Requirements ............................ 11
Exhaust Requirements ......................................... 11
Electrical Information ........................................... 13
Gas Information ................................................... 16
Converting from One Family of Gas to Another ... 19
Gas Pressure Testing ........................................... 21
Steam Information ................................................ 21
Water Information ................................................ 22
Preparation for Operation/Start-Up ...................... 23
Preoperational Test .............................................. 23
Preoperational Instructions .................................. 24
Shutdown Instructions .......................................... 24
Service/Parts Information .................... 25
Warranty Information ........................... 25