Sonnet Technologies G5 Jive - Manual (Page 4)

4
Figure 12
Figure 11
Figure 10
Installation Steps for Power Mac G5 with PCIe Slots
Install G5 Jive Base Plate
1. Locate and remove the screw from the floor of the computer in
front of the RAM slots (Figure 9).
2. Insert the G5 Jive’s base plate into the computer with the long
folded edge face down and the raised tab facing out (Figure 10).
3. Slide the folded edge of the base plate over the front edge of the
computer’s floor, and align the base plate’s screw hole with the
screw hole in the floor
(Figure 10).
4. Using the provided long screw, secure the base plate to the com-
puter; do not overtighten the screw (Figure 11).
Install Drives into G5 Jive Drive Mounting Bracket
1. Set the drive mounting bracket on its side with the raised tab fac-
ing left (Figure 12).
2. Handling it by its edges, insert a Serial ATA drive into the drive
bracket with the drive’s label facing you, and then align the holes
in the bracket with the screw holes in the drive
(Figure 12).
3. Using the provided drive mounting screws, secure the drive to
the drive mounting bracket (Figure 12).
4. Repeat steps 1-3 for any additional drives.
tab
base plate
screw (provided)
tab
SATA drive
tab
screw (provided)
folded edge
Figure 9
screw