Sonnet Technologies G5 Jive - Manual (Page 11)

11
Figure 38
Figure 37
Figure 36
Figure 35
Installation Steps for Power Mac G5 with PCI-X Slots
2. Insert the G5 Jive’s base plate into the computer with the long
folded edge face down and the raised tab facing out (Figure 35).
3. Slide the folded edge of the base plate over the front edge of the
computer’s floor, and align the base plate’s screw hole with the
screw hole in the floor
(Figure 35).
4. Using the provided long screw, secure the base plate to the com-
puter; do not overtighten the screw (Figure 36).
Install Drives into G5 Jive Drive Mounting Bracket
1. Set the drive mounting bracket on its side with the raised tab fac-
ing left (Figure 37).
2. Handling it by its edges, insert a Serial ATA drive into the drive
bracket with the drive’s label facing you, and then align the holes
in the bracket with the screw holes in the drive
(Figure 37).
3. Using the provided drive mounting screws, secure the drive to
the drive mounting bracket (Figure 37).
4. Repeat steps 1-3 for any additional drives.
Install Drives into Computer
1. Connect the right-angle connectors from the supplied SATA
data cables to the drives; verify the connectors are plugged in
securely (Figure 38).
tab
base plate
screw (provided)
tab
SATA drive
tab
screw (provided)
data cable
data cable
data cable
folded edge
PC
I-
X
Po
w
er
M
ac
G
5
In
st
al
l