Sonnet Technologies Fusion QR (With Drives) - Manual (Page 6)

Connect Fusion QR to Computer and Power Outlet
1. Using one of the supplied cables (eSATA, FireWire 800, USB 3.0),
connect the Fusion QR to your computer (Figure 1).
2. Connect the included power cord between a wall outlet or power
strip and the power adapter; verify the connector is plugged in
securely;
verify the cable is plugged in securely (Figure 1).
3. Connect the power adapter cable to the Fusion QR’s 19V power
socket; verify the cable is plugged in securely (Figure 1).
4. If you are a Windows® user, or a Mac® user wishing to change
the drive mode from the default RAID 5 configuration, do not
turn on the QR’s power yet; you must first follow the instructions
to select the drive mode. Refer to page 6 for descriptions of the
various configuration modes available, or go to the next page for
directions on how to set the drive mode.
Access Drives and Mode Switch
If you wish to change the drive mode, or merely want to access the
drives, you must remove the front cover from the QR.
1. Remove the Fusion QR from its packaging, and place it on a flat,
level surface, with the front panel facing you.
2. Lift up the front of the enclosure, slide the inner chassis lock
switch to the left and hold it (Figure 2), and then push the inner
chassis from the back until it stops (Figure 3).
3. Pull the front panel toward you, and then lift it off of the
enclosure (Figure 4). Set the panel aside.
2 – Enclosure Setup; Access Drives and Mode Switch
2
Support Note: The supplied Sonnet locking eSATA cable is
compatible with all eSATA ports and provides a far more
secure connection when used with Sonnet drive enclosures and host
controller cards with the matching connector. If necessary, you may
remove the locking mechanism from the connector by removing the
screws securing the two halves.
Figure 1
Figure 3
Figure 2
Figure 4
push the inner
chassis in until
it stops
pull out the top
edge, and then
lift off the cover
slide lock switch to
left, and hold it