1 – fusion qr features – Sonnet Technologies Fusion QR (With Drives) User Manual

Page 5

1 – Fusion QR Features

1 – Power Indicator

This blue LED lights when the Fusion QR is powered.

2 – Presence, Activity, and Fault Indicators — Drives A – C

These LEDs indicate the ready state (solid green), read and
write activity (flashes green), and fault status (OFF or red) for
drives A – C. An LED will remain off if the corresponding
drive is not recognized, and will turn red if the drive is
recognized but can’t be used.

3 – Mode Change Confirmation; Drive D Presence, Activity,

and Fault Indicator
When setting the drive mode, this LED stays off, or lights
green, orange, or red depending on the mode selected. It also
indicates drive D’s ready state (solid green), read and write
activity (flashes green), and fault status (off or red). The LED
will remain off if the corresponding drive is not recognized,
and will turn red if the drive is recognized but can’t be used.

4 – Drive Mode Selection Switch

Select the drive mode setting using this switch.

5 – Erase and Set Mode Switch

Press and hold this switch for three or more seconds upon
powering the system to activate the selected drive mode.

6 – Drive Modules

To remove a drive module, turn the thumbscrew counter-
clockwise until it pops out, and then pull out the module.
To place a drive module, insert it into the drive bay until it
stops, push in the thumbscrew until it stops, and then turn it
clockwise until it stops;

do not overtighten the thumbscrew.

7 – Inner Chassis Lock Switch

Slide this switch to the left to allow you to remove and replace
the front cover.

A – Security Slot

This slot works with Kensington

brand and similar security

locks to secure the Fusion enclosure and deter theft.

B – Power Switch

C – Locking eSATA Interface Port

This port is compatible with the included Sonnet locking
eSATA data cable and standard eSATA data cables.

D – FireWire

800 Interface Ports

In addition to FireWire 800, these ports support FireWire
400 connections on computers and adapter cards when used
with a FireWire 400-to-FireWire 800 adapter or adapter cable.

E – USB 3.0 Interface Port

F – 19V DC Power Socket

Connect the included DC power adapter between this socket
and the included power cord.

❺

❻

❼

❻

❹

❸

❷

❶