SecurityMan NiteCam2 User Manual

Page 17

1. Manual mode: Slide Mode Control switch to M to enter Manual

mode. In this mode, the receiver channel won’t change until you

press the Channel Select Button “CH”

2. Channel Scan mode: Slide Mode Control switch to L to enter

channel scan mode. In this mode, all the available channels will display

one by one looping in turn per 5s. So you can watch the situations from

up to 4 different cameras via one receiver.

Tip:

Channel-Scan function can also be activated by pressing and holding the

Channel Select Button "CH" for more than 5 seconds in Manual mode.

Press the

Channel Select Button again to deactivate Channel-Scan function.

Note:

Press the

Channel Select Button "CH" at the channel scan mode, the current

channel will be looped to the next channel immediately.

Slide the

Mode Control switch to M to exit the channel scan mode.