Securitron CCB_Series User Manual

Slave board master board

Securitron Magnalock Corp.

www.securitron.com

ASSA ABLOY, the global leader

Tel

800.624.5625

[email protected]

in door opening solutions

PN# 500-10350

Page 1

Rev. B, 07/11

CCB-8-12 / CCB-8-24 SLAVE BOARD

INSTALLATION INSTRUCTIONS

1. DESCRIPTION
The CCB-8-12/24 allows the addition of eight individually Polyswitched outputs to an existing
power supply. The power supply’s total current capacity remains the same. The CCB-8-12/24

may be installed into the existing power supply enclosure via the provided snap-trak. The CCB-
8-12/24 is not compatible with the Securitron 1 amp power supply.

FUSE

SLAVE BOARD

MASTER BOARD

BLACK WIRES

RED WIRES

Figure 1

2. INSTALLATION & WIRING
It is recommended that the CCB-8-12/24 be mounted below the main distribution board. The
CCB-8-12/24 comes standard with four 8” flying leads. Prior to installation, ensure that you
have the correct version of the CCB board for the power supply as they are available in 12 VDC
or 24 VDC.

The CCB board has 4 wires (2 red wires and 2 black wires) which must be soldered to the main

distribution board. Remove AC power and disconnect the battery leads from the battery before
soldering. The 2 black wires should be soldered to the main board’s “S-” solder points. The 2
red wires should be soldered to the main board’s “S+” solder points (as shown in Figure 1).

Note: Any modification to the Power Supply including the addition of the CCB will void

the UL Certification.