Robinair 34134-2K Refrigerant Recovery, Recycle, Recharge Unit - Manual (Page 9)

7
34134-2K Recovery, Recycling and Recharging Unit
SETTING UP THE UNIT
To set up the unit to an R-134a vehicle:
1. Attach the 60" blue hose to the low side port of the manifold.
2. Attach the 60" yellow hose to the center port of the manifold.
3. Attach the 60" red hose to the high side port of the manifold.
4. Place the assembled manifold onto the manifold support bracket on the back
of the unit.
5. Attach the yellow hose from the manifold to the access port on the back of the
unit.
6. Connect the tank adapter (included with the unit) to the LIQUID port (blue)
of the tank. Attach the blue low side hose from the manifold to the tank
adapter.
NOTE: Use ONLY the tank adapter included with this unit. Use of any other
adapter could result in damage to the compressor, voiding the manufacturer's
warranty.
7. Attach the red vapor hose from the back of the unit to the GAS (red vapor)
valve on the tank.
8. Attach the air purge hose to the air purge fitting on the unit tank.
9. Open both valves on the manifold.
10. Open both valves on the tank.
11. Open the service coupler on the blue low side hose.
12. Verify that the RECOVER/VACUUM switch (see page 4 for switch location)
is in the OFF position.
13. Attach the power cord to the back of the unit (see page 5) and connect to the
correct voltage outlet on the vehicle.
14. Turn the switch on the control panel to VACUUM.
15. Allow the unit to run for 5 minutes.
16. Turn the RECOVER/VACUUM switch to OFF.
17. Close the high side manifold valve (red).
18. Close the service coupler valve on the blue low side hose.
19. Close the LIQUID valve (blue) on the tank.
20. Disconnect the service coupler from the tank adapter.
21. Remove the tank adapter from the tank.
22. Attach LIQUID hose from the back of the unit to LIQUID port on the tank.
Open the LIQUID valve on the tank.
23. Reconnect the tank adapter to the hose holder for storage.
Set-Up Instructions