Rivers Edge RE619 LumberJack Extrme - Manual (Page 39)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 39
Operator's Manual
Rivers Edge One-Man Ladder Stands
Wrap entire ratchet assembly around tree and hook other "S" hook through
opposite tree blade hole. Pull tail of long strap until most of the slack is
taken out. Be sure entire strap is even and at the same level all around tree.
"Ratchet" tight to tree, this will securely attach ladder to tree and prevent
movement. SEE fIGuRES 5a, 5b, AND 7.
notE: to release ratchet, simply pull the release lever and open tightening
lever wide open (flat).
5. for RE623 and RE624 ONlY: Repeat step 4 for second tree blade
attachment by placing “S” hooks through holes provided on second tree
blade. SEE fIGuRES 5b, 6, AND 7.
6. If applicable, attach backrest portion of seat to tree by wrapping the long
strap with buckle end around tree and snapping together with opposite
end. Adjust as needed.
7. If applicable, once seated, shooting rail can now be seated down over studs.
SEE fINIShED lADDER IlluSTRATIONS.
8. fOR RE607, RE619, and RE624: Reverse setup and use instructions to
take ladder down. This now completes the set-up instructions for RE607,
RE619 and RE624. fOR RE623, PlEASE CONTINuE AS INSTRuCTED ON
ThE fOllOWING PAGE TO PROPERlY INSTAll YOuR SWIvEl SEAT.
TREE
Figure 7
ratchet
back and forth
Figure 6
pull tail to take out slack
tightening lever
release lever
feed through slot