Rivers Edge RE619 LumberJack Extrme - Manual (Page 11)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 11
Operator's Manual
Rivers Edge One-Man Ladder Stands
ASSEMBlY INSTRuCTIONS (RE619)
Tools needed – two 7/16" wrenches, rubber mallet
iMpoRtant aSSEMblY tip: do not tighten any nut and bolt combinations
completely until all parts are assembled together! Finger tighten plus one
turn of a wrench only! this will temporarily hold the lock nut on the bolt while
helping alignment of all parts! after all parts are assembled together, all nut
& bolt combinations must be completely tightened.
1. Attach the foot platform (1ML37) to the inside of side rails (SL61) using (2)
provided 1/4-20 x 2-1/4” bolts and locknuts. SEE fIGuRE 1. DO NOT tighten
all nut & bolt assemblies completely!
notE: Mesh surface should be on top with squared ends of platform closest
to side rails.
2. Attach the rear (blade end) of tree blade frame (1ML34) to the inside of side
rails, and the (2) armrests (AR12) to the outside of side rails using (2) provided
1/4-20 x 3-1/4” bolts, locknuts and steel washers. SEE fIGuRE 2.
3. Attach the front end of tree blade frame to the side rails and the front end
of armrests to the side rails using (4) provided 1/4-20 x 2-1/4” bolts, lock
nuts and (2) steel washers. SEE fIGuRE 2.
4. Attach the seat frame (1ML15) to the tabs on the tree blade frame using (2)
provided 1/4-20 x 1-1/2” bolts, locknuts, steel washers and nylon washers.
SEE fIGuRE 3. Attach the (2) provided rubber bumper stops to the top side
of tree blade frame by pressing into provided holes. SEE fIGuRE 3.
notE: Mesh surface of seat frame should be on top.
notE: nylon washers should be placed between the tabs and seat frame
to prevent noise.
Figure 1
Figure 2
Figure 3
cutout view
of foot platform
1/4-20 x 2-1/4”
bolts
locknuts
side rails
1/4-20 x 2-1/4” bolts
armrest
locknuts
locknuts
tree blade frame
seat frame
1/4-20 x 1-1/2” bolts
rubber bumpers
tabs
nylon washers
steel washers
tree blade frame
side rails
shooting rail
mounts
steel washers
1/4-20 x 3-1/4” bolts
steel washers