Rivers Edge RE712 14' PERIMETER - Manual (Page 4)

TREESTANDS
14' Perimeter ™ Ladder Pod (RE712)
Page 4
HuntRiversEdge.com
HuntRiversEdge.com
800-450-EDGE (3343)
10. Attach the shooting rail front rail to the shooting rail side rails using (2)
provided 1/4-20 x 1-1/4” bolts and locknuts. SEE FIGURE 5. Side rails
should be inserted into the front rail and bolts should go through both
rails.
11. a. Attach the removable seat cushion (48126) to the top of seat frame.
Wrap the Velcro straps around seat frame and secure together. Pull
straps tight so seat is not loose.
b. Attach backrest pad (48858) to the backrest rim by wrapping around
metal tubing and attaching Velcro together.
c. Attach the 66” camo sleeve (48874) to the shooting rail by wrapping
around metal tubing and attaching Velcro together. The pad will act as
a noise dampener between shooting rail and armrests.
12. Attach the ladder foot pads (TP113) to the bottom (short) ladder (TP159)
using (2) provided 1/4-20 x 1-1/2” bolts and locknuts. SEE FIGURE 7.
This step now makes this the bottom ladder section.
NOTE: Channel on foot pads should touch on three sides of the
ladder legs. SEE FIGURE 7.
13. Assemble all ladder sections together and attach them to the assembled
platform in the following order: attach top ladder (SL51 ladder) onto the
J-receiver tubes; attach middle ladder (SL51 ladder) onto the top ladder;
attach bottom ladder (TP159 ladder with feet) onto the middle ladder.
NOTE: Make sure foot pads are orientated out, away from
platform.
14. Attach (6) single support brace tabs (TP115) to each joint location of
ladder assembly (6 total locations) and secure those locations using (6)
provided 1/4-20 x 1-3/4” bolts and locknuts.
SEE FIGURE 7.
15. Assemble all leg sections together and attach them to the assembled
platform in the following order: Insert (2) top legs (TP145) into the leg
pockets attached to the platform; insert (2) middle legs (TP145) into the
top leg pockets; insert (2) bottom legs with feet (TP147) into the middle
leg pockets.
wARNING
LUBRICATION IS HIGHLY RECOMMENDED AT SLIDE
TOGETHER POINTS OF EACH SECTION TO PREVENT
BINDING. SECTIONS ARE STACKED TOGETHER BY
SLIDING SECTIONS TOGETHER, INSIDE OF EACH
OTHER.
BE SURE ALL LADDER AND LEG SECTIONS ARE SEATED
COMPLETELY TOGETHER ON POCKETED ENDS OF
PIPE.
FIGURE 6
locknuts
armrests
1/4-20 x 2" bolts
nylon washers
1/4-20 x 2" bolts
backrest rim
steel washers
seat frame
1/4-20 x 1-1/4" bolts
shooting rail front
1/4-20 x 1-1/4" bolts
shooting rail sides
NOTE: Longer side of
armrest here
NOTE: Longer side of
side rail here