Rivers Edge RE629 15' 2-Man Ladder Stand - Manual (Page 13)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 13
Operator's Manual
Rivers Edge Two-Man Ladder Stands
Figure 7
Figure 8
spring lock pins
36" camo sleeve
support braces
1/4-20 x 2-1/4" bolts
locknuts
shooting rail
10. Sections are assembled on the ground in the following order: bottom section
(SL51 ladder); second section (SL52 ladder); third section (SL54 ladder); top
section (assembled top platform section). SEE FINISHED 17’ DOuBlE BuCk
EXTREME TWO-MAN lADDER.
11. With all sections assembled together on ground, secure all sections together
using (6) provided spring lock pins. Handle of spring lock pin must be put
to the outside of ladder side rails. SEE FIGuRE 7.
12. Attach the (2) support braces (2ML46) to the outside of platform J-pipes
and 4-step ladder section with mounting holes using (4) provided 1/4-20
x 2-1/4” bolts, and locknuts. SEE FIGuRE 8. You must now tighten all nut
& bolt assemblies. Be sure not to over tighten or crush tubing when
tightening!
13. a. Attach the removable seat cushion (48688) to the top of seat frame. Wrap
the velcro straps or buckle straps around seat frame and secure together.
Snap the side release buckles together for buckle style seats. Pull straps
tight so seat is not loose. Attach backrest portion by wrapping Velcro around
backrest rail and securing.
b. Attach (2) provided 9" and (1) 36" camo foam sleeves to the backrest rail
(armrest) and shooting rail by simply wrapping around square tubing and
attaching Velcro together.
14. a. Attach the stabilizer bar extension tube (1ML23) to the second ladder section
mounting bracket using (1) provided spring lock pin. SEE FIGuRE 9.
b. Slide the stabilizer bar (L17) into the extension tube and attach the two
pieces together using (1) provided spring lock pin. Spring lock pin must go
through both the extension tube and the stabilizer bar at appropriate hole
to achieve desired distance from tree. Adjustment in length may be needed
when ladder is uprighted later in instructions. SEE FIGuRE 9.
15. a. Tie one end of the provided 9’ rope to the link welded onto the stabilizer
bar, just in front of the tree hugger. Be sure your double knot is secure.
SEE FIGuRE 10.
b. Tie one end of each of the provided 15’ ropes to the platform J-pipes,
just in front of the bolt-on tree blade. Be sure your double knots are secure.
SEE FIGuRE 10.
Figure 9
stabilizer bar
spring lock pins
Figure 10
extension tube
4-step ladder section
w/mounting holes
platform J-pipes
seat platform
9" camo sleeves
seat cushion