Reversomatic Deluxe Series - Manual (Page 14)

Air Flow Balancing (cont’d)
DUCT DIAM .
5"
6"
CROSS SECTION AREA
0.136 sq. ft.
0.196 sq. ft.
The accuracy of the flow reading will be affected by how close to any elbows or bends the readings are taken.
Accuracy can be increased by taking an average of multiple readings as outlined in the literature with the Pitot tube.
MAGNEHELIC 0 .1 .2 .3 .4 .5
MAGNEHELIC 0 .1 .2 .3 .4 .5
Magnehelic
gauge
Pitot
tube
Pitot tube
Min 3 ft straight duct
(option #1)
Min 3 ft straight duct
MAGNEHELIC 0 .1 .2 .3 .4 .5
(option #2)
(option #2)
Note: To take more accurate readings, use option #1(if possible).
Note:(Option #2)
*For balancing, extension box cover plate is
provided with 3 holes on supply side and 3
holes on exhaust side.
*Do not use pitot tube to open holes in the
insulation as it may block/damage the pitot tube.
*Take 3 readings on each hole and average
all 9 readings for supply and same for exhaust.
*After finish balancing, plug all six holes with
plastic plugs provided with the unit.
Extension box cover plate
CFM = Opening / Cross-sectional Area(sq.ft.) x velocity(FPM)
Opening area: 0.2196sq.ft.
MAGNEHELIC 0 .1 .2 .3 .4 .5
Opening area: 0.136 sq.ft.
1. Turn the unit off and disconnect the power supply.
2. Unlatch the door and lift the door panel towards you, hold it firmly and slide it to the left.
3. Clean the inside of the door and drain pan with a damp cloth to remove dirt and debris
that may be present.
4. Clean the filters: (twice a year)
- Remove the filters.
- Vacuum to remove most of the dust.
- Wash with a mixture of warm water and mild soap. Rinse thoroughly and shake filters
to remove water and let dry.
6. Check the exterior fresh air supply hood:
- Make sure there are no leaves, twigs, grass, ice or snow that could be drawn into the vent.
Partial blocking of this air vent could cause the unit to malfunction.
7. Reassemble the components, Filters and Door (The door is secured when you hear a click.)
8. Reconnect the power and turn on the unit.
5. Oil defrost damper levers and hinges.
Regular Maintenance
12
Maintenance
Ш5 Ш6
0.010 0.004 50
0.012 0.006 60
0.016 0.008 70
0.022 0.010 80
0.027 0.013 90
0.034 0.016 100
0.041 0.020 110
0.048 0.023 120
0.057 0.027 130
P" CFM
P = Velocity Pressure in inch "