Ransburg 9040 Cascade LV Control Unit 76580 - Manual (Page 24)

CP-97-04.3 2 1 2 1 2 1 2 1 2 1
9040 Cascade Low Voltage Control Unit - Operation
> >> > > The user MUST MUST MUST MUST MUST read and be familiar with
the SAFETY PRECAUTIONS and SAFETY PRECAUTIONS and SAFETY PRECAUTIONS and SAFETY PRECAUTIONS and SAFETY PRECAUTIONS and
SAFETY SECTIONS SAFETY SECTIONS SAFETY SECTIONS SAFETY SECTIONS SAFETY SECTIONS of this manual and
the ITW Ransburg safety literure therein
identified BEFORE OPERATING
BEFORE OPERATING BEFORE OPERATING BEFORE OPERATING BEFORE OPERATING the 9040
Cascade control unit.
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G !!!!!
OPERA OPERA OPERA OPERA OPERATION TION TION TION TION
> >> > > The electrical discharge that is available
from the charging electrode of the applicator
must not exceed 0.25 mJ of energy. To
achieve this limit, any flow of energy from the
paint supply through the paint line to the
applicator electrode must be prevented by
grounding the paint line at the applicator
handle or body.
> > > > > Verify that the applicator is actually
grounded before operating it! (See the
appropriate applicator manual.) If improper
readings are obtained, check that the control
unit is grounded. (See “Ground Test
Procedures” in the “Maintenance -
Troubleshooting” section of this manual.)
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G !!!!!
Figure 8: Operating Controls Figure 8: Operating Controls Figure 8: Operating Controls Figure 8: Operating Controls Figure 8: Operating Controls
ARCHIVE