Archive, Specifica, Specifica specifications tions tions tions tions – Ransburg 9040 Cascade LV Control Unit 76580 User Manual
Page 12
CP-97-04.3
9
9
9
9
9
9040 Cascade Low Voltage Control Unit - Introduction
SPECIFICA
SPECIFICA
SPECIFICA
SPECIFICA
SPECIFICATIONS
TIONS
TIONS
TIONS
TIONS
Environmental / Physical
Environmental / Physical
Environmental / Physical
Environmental / Physical
Environmental / Physical
Electrical Requirements
Electrical Requirements
Electrical Requirements
Electrical Requirements
Electrical Requirements
Input:
Input:
Input:
Input:
Input:
V
V
V
V
Voltage
oltage
oltage
oltage
oltage
90-264 VAC
Currentr:
Currentr:
Currentr:
Currentr:
Currentr:
0.4/0.2 Amps AC
Frequency:
Frequency:
Frequency:
Frequency:
Frequency:
50/60 Hertz
W
W
W
W
Wattage:
attage:
attage:
attage:
attage:
40 Watts (Maximum)
Output:
Output:
Output:
Output:
Output:
V
V
V
V
Voltage:
oltage:
oltage:
oltage:
oltage:
0-10 V RMS
Current:
Current:
Current:
Current:
Current:
1.5 Amp RMS (Maximum)
Pneumatic
Pneumatic
Pneumatic
Pneumatic
Pneumatic
Supply Air:
Supply Air:
Supply Air:
Supply Air:
Supply Air:
100 psi maximum
Height:
Height:
Height:
Height:
Height:
5.2-Inches
Width:
Width:
Width:
Width:
Width:
16.9-Inches
(19-Inches ear to ear)
Depth:
Depth:
Depth:
Depth:
Depth:
12.1-Inches
Weight:
Weight:
Weight:
Weight:
Weight:
15 lbs.
The 9040 Cascade control unit is available from
the factory in the following versions only:
1. One control unit with no Totalizer or Pneumatics
modules
2. One control unit with one Totalizer module and
no Pneumatics module
3. One control unit with one Totalizer module and
one Pneumatics module
4. One control unit with one Pneumatics module
and no Totalizer module
For applications requiring two Totalizer or
Pneumatics modules in a rack with one control
unit, the required modules can be purchased
separately as a kit. (See “Parts Identification”
section.)
The 13742-01 Air Flow Switch assembly used in
the following 9040 Control Units has a maximum
working pressure of 100 psi:
76580-1XXXX REA 70 Applicator
76580-6XXXX REA90 Waterborne Applicator
76580-7XXXX REA90 Solventborne Applicator
Exceeding this pressure may cause the flow
switch to burst. Ensure that the air input to the IN
port of the flow switch on these units is supplied
from a 100 psi or less regulated and filtered air
supply.
ARCHIVE