Ransburg Serial Atomizer Module A11925-00 - Manual (Page 25)

LN-9256-07.4
MANUAL MANUAL MANUAL MANUAL MANUAL CHANGE SUMMAR CHANGE SUMMAR CHANGE SUMMAR CHANGE SUMMAR CHANGE SUMMARY Y Y Y Y
This manual was published to supercede Service
Manuals
LN-9256-07.3 Serial Atomizer LN-9256-07.3 Serial Atomizer LN-9256-07.3 Serial Atomizer LN-9256-07.3 Serial Atomizer LN-9256-07.3 Serial Atomizer
Module Module Module Module Module to make the following changes:
1. In the "Operation" section, revised Figure 5:
Dip Switch Settings.
2. In the "Operation" section, page 10, revised
note to add "When using multiple Serial Atomizer
Modules, the Node Adapter must be set to Flex
Mode communication (see Figure 5 for switch
settings)."
3. In the "Parts Identification" section, page 20,
revised left column note to "Connect terminal #8
to earth ground and to pneumatic motherboard
TB1 terminal 2." and revised right column note to
"If 24 VDC is used, do not connect 5 VDC
terminal."