Ransburg Serial Analog Module A11012 - Manual (Page 10)

LN-9258-07.2
Serial Analog Module - Installation
INSTALLATION
CONNECTIONS
Connections
The Analog Module plugs into the 78147 Mother
Board (74847 for Retrofit Applications) which
takes one quarter of a 19" rack. Three slots are
available for Analog Modules. Besides canbus
communi-cation to the Node Adapter through
motherboard terminals J4, discrete communication
is accomplished through motherboard terminals
J5, J8, or J11.
Pneumatic Connections
The Analog Module uses the following pneumatic
edge connector ports:
CH1 Sense 2 (-01 model only)
CH2 Sense 3 (-01 model only)
CH1 Output 4
CH2 Output 5
Supply Input 9 (bottom)
7
> For stable module operation, the tubing
connected to the pneumatic outputs must
be 35 ft. long (for 5/32" tubing).
NOTE
> It is extremely important to prevent con-
tamination of the valves and air passages
inside the module. Adhering to the speci-
fications of 100 psig max. and 40 micron
filtration on the supply air is critical. Since
the valve can also be contaminated through
the output port, filtration is recommended
on output lines also.
C A U T I O N
!
CH1 Analog Input
CH2 Analog Input
CH1 Analog Output
CH2 Analog Output
CH1 Digital, Out, Stable
CH2 Digital, Out, Stable
CH1 Digital, Out, Local
CH2 Digital, Out, Local
Backplane Terminal Signal Name
V1
V4
V3
V6
V2
V5
V7
V8
ELECTRICAL CONNECTIONS
Electrical Connections
The Analog Air control Modules uses a DIN 41612
B connector. Pin assignments are as listed below.