Ransburg Discrete IO Module A11435 - Manual (Page 18)

Starting and Configuring
HyperTerminal Software
1. Start the HyperTerminal software (START/
ACCESSORIES/COMMUNICATION/HYPER-
TERMINAL).
2. The software will ask for a name of the new
connection (If necessary, select File: New Connec-
tion). Type a name such as Discrete IO and save
to a convenient location such as the desktop view.
3. Set the following communication settings:
• Press File: Properties: and set “Connect
using” parameter to Direct to Com X (X denotes
the computer port being used).
• Press configure and set the following
parameters:
Bits per second: 19200, Data Bits: 8, Parity:
None, Stop Bits: 1, Flow Control: None,
• From this point, save the configuration by
pressing File, Save.
• Exit the program and restart by double-
clicking the saved file icon.
The MicroPak indicators are as follows:
kV, uA, the air and fluid trigger status (EFM guns),
HV OFF and HV ON status, Di/dt setting, the Flt
status, HV Ready, LOCal/remote switch position,
Overcurrent fault status, Feedback fault, sequence
state (EFM guns), kV out of Tolerance, and kV
low status.
Note: The di/dt inhibit command is shown, but
the status is not.
The Serial Atomizer indicators are as follows:
Speed, (Turbine Drive) Pilot Pressure, Bearing Air
Pressure, Bell Run status, Low Bearing Air status,
Invalid Data (speed setpoint is above operating
range of applicator), Loss Of Feedback, Under
Speed, Over Speed, and Speed Out of Tolerance.
For information on a specific fault, refer to the
previous sections of this manual or the current
Serial Atomizer module manual.
The first section details the input and outputs regarding the MicroPak.
The next section shows the inputs and outputs regarding the Serial Atomizer.
The Status row shows the real time status of the device.
The Command row shows the actual command coming in from an external device.
Discrete I/O Monitor, v1.2
HV HV Di/dt HV
MicroPak: kV uA AIR FLD OFF ON Set Flt RDY LOC OVL FBK SEQ OOT LOW
Status: 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Command: 0 0 0 0 0 0 0
Pilot Bearing BELL Low Inv. Under Over Out of
Atomizer Speed Press Air RUN B.Air Data LOF Speed Speed Tol
Status: 0 1 0 0 1 0 1 0 0 0
Command: 0
Discrete I/O Module - Safety
15 LN-9253-06.1
Ransburg