Ransburg Discrete IO Module A11435 - Manual (Page 13)

Digital Inputs
24 VDC source (SW7, 8 Up) or sink SW7, 8 Down)
Ground Reference 18A, 14A, or 13A.
High Voltage On - If High Voltage Ready is active,
causes high voltage to be present at cascade
output
High Voltage Reset - Turns off High voltage, over-
riding High Voltage ON signal, also reset faults
conditions
Fluid Trigger - Causes Fluid Trigger to MicroPak to
be active
Air Trigger - Supplying 24 VDC causes air trigger to
EFM gun to be active.
Di/dt Inhibit - Supplying 24 VDC causes di/dt to be
disabled.
Bell Spin Enable - Causes speed setpoint to be
sent to Serial Atomizer Module, also used for fault
reset BLU/BLA
ORG/BLA
RED/BLA
WH/RED
ORG
BLU/WH
Wire Color Description
20C
19C
17C
16C
15C
9C
Pin #
Source/Sink
Control
SW7
SW7
SW7
SW7
SW8
SW8
TABLE 3 - DIGITAL INPUTS
Discrete I/O Module - Safety
10 LN-9253-06.1
Ransburg