Ransburg Evolver SE Robotic Atomizer A12455-XXXXXXXX - Manual (Page 10)

AA-09-01.1 : Evolver SE
Section 2: INTRODUCTION
The Evolver SE is an automatic robot mounted spray applicator capable of spraying solvent borne or waterborne coat-
ings electrostatically or non-electrostatically. It incorporates a unique 1/3 turn quick disconnect spray head. The spray
head and valve manifold contain fluid and air passages. All fluid passages contain stainless steel and/or plastic fittings,
compatible with halogenated hydrocarbon solvents.
SPECIFICATIONS - Environmental / Physical
Robot / Mounting Compatibility: All non-hollow and hollow wrist robots, Paint Mate, reciprocator and stationary stands.
Operating Voltage: 85 kV maximum with 9050, 9040 or Voltage Master power supply.
Operating Temperature Range: 55 0F (12.8 °C) to 131 0F (55 °C)
Weight: SE with gun, manifold and bracket = 3.35 lbs (1.52 kg) max.
SE with gun, manifold, dump block and bracket = 3.60 lbs (1.64 kg) max.
Length: Dependent on configuration (see configuration drawings)
Paint Flow Rate: Variable to 500 cc/min.
(depending on viscosity and configuration)
Trigger Response Time: 150 msec. OPEN
220 msec. CLOSED
Operating Air Pressures:
Atomizing Air: 100 psig max. (6.9 bar)
Fan Air: 100 psig max. (6.9 bar)
Trigger Air: 70 psig min. - 100 psig max. (4.8 - 6.9 bar)
Dump Pilot: 70 psig min. - 100 psig max. (4.8 - 6.9 bar)
Operating Fluid Pressure: 100 psig max. (6.9 bar)
Tubing Requirements:
Atomizing Air: 5/16" (8mm) OD Nylon
Fan Air: 5/16" (8mm) OD Nylon
Trigger Air: 5/32" (4mm) OD Nylon
Dump Pilot: 5/32" (4mm) OD Nylon
Fluid (PTFE): 5/16" (8mm) non-shielded
Fluid (optional): 3/8" OD shielded (for waterborne or highly conductive materials)
Dump (PTFE): 5/16" (8mm)
Robot Wrist Movement: Axis 6 limit to 430°