Lanair 215 Gallon Tank With Bypass Regulator - Manual (Page 5)

Visit our website at: www.lanair.com 5
Section 2 - Installation Instructions
TANK INSTALLATION
1. Unwrap the tank and parts.
2. Choose tank location. Locate the tank in an
area that is protected from lift truck and motor
vehicle traffic. NOTE: Make sure you have
enough room to install and service your heater.
3. Anchor all four legs of the tank to the floor as
indicated In Fig. 1. NOTE: This method of
anchoring is a suggestion only. Anchoring
methods may vary per individual applications
and environments. Check state and local codes
for clarification.
4. Install the four tank legs included with the tank
on top of the bottom legs (see Fig. 2).
5. Using a forklift, lift and center the heater on top
of the platform. NOTE: The front of each unit is
indicated on the top of the tank platform
6. Using a forklift, carefully raise the platform and
heater assembly and place on top of the previ-
ously installed legs (see Fig. 2).
7. Locate the four holes on the bottom side of
the heater platform. Attach the heater to the
platform using four #10 x 1" screws provided.
Concrete Anchor
(not included)
FIGURE 1
FIGURE 2
Top Tank Leg
Heater
Assembly
Burner
on Right
Bottom Tank
Leg
Platform
Pump
Platform
Label