Kasco Marine LED6125 - Manual (Page 3)

3
3. Place rubber caps over the light fixtures as shown.
Ensure the rubber cap is seated all the way down onto
the fixture housing. If this is not on a new light kit,
make sure the fixture and lens are clean before install-
ing the rubber cap.
Fig 3
Instructions for mounting lights on model:
2400VFX, 3400VFX, 3400HVFX, 3400J, 3400HJ,
4400VFX, 4400HVFX, 4400J, 4400HJ
4. Insert the 1/4” x 1-3/8” bolt into the light fixture
bracket. Align the light fixture bracket to the float
tab by placing the bolt through the light mounting
hole (light fixture bracket is on top of the float tab) as
shown in Figure 4.
Fig 4
5. Install the 1/4” Flat Washer, 1/4” Lock Washer
and 1/4” Nut against the underside of the float tab as
shown in Figure 5. Tighten the nut until snug using
the 7/16” Wrench.
Fig 5
flat washer
lock washer
1/4” nut
LED6125
• A. Includes two (2) sets of LED3125 (see parts
included in LED3125
• B. Lower float brackets (6)
• C. 3/8” washers (3)
TOOLS & SUPPLIES NEEDED
• A. Two 7/16” Wrenches (or one wrench & a 7/16
socket with driver)
• B. Diagonal Pliers or Cutter for Nylon Zip Ties
LED3125 Assembly Instructions
For ease of assembly, make sure the Aerating Fountain
is completely assembled. Place the assembly upright.
1. Install the mounting brackets to the light fixtures by
fitting the head of the #10 screw into the tabs on each
side of the fixture. Tighten the thumb screws on each
side hand tight only.
Fig 1
Installing Color Lenses:
If you desire to change to one of the color choices
instead of the standard white light, follow these steps.
2. Unpeel the protective backing from both sides of
the colored lens on the color of your choice. Place the
lens inside the rubber cap making sure the 3 flaps are
holding the lens in place. Do this for all 3 lenses.
Fig 2