beautypg.com

Mediashield™ controller, Right angle side, Asus m2n-e sli 2-25 – Asus M2N-E SLI User Manual

Page 45: M2n-e sli ide connectors, Pri_ide, Sec_ide, M2n-e sli sata connectors, Sata3, Sata4, Sata1

background image

ASUS M2N-E SLI

2-25

3. Serial ATA connectors

(7-pin SATA1, SATA2, SATA3, SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA

3.0 Gb/s hard disk and optical disk drives. The Serial ATA 3.0 Gb/s is

backward compatible with Serial ATA 1.5 Gb/s specification.
If you installed Serial ATA hard disk drives, you can create a RAID 0,

RAID 1, RAID 0+1, RAID 5, or JBOD configuration through the onboard

NVIDIA

®

MediaShield™ controller.

The RAID function of these connectors is set to [Disabled] by default.

If you intend to create a Serial ATA RAID set using these connectors,

enable the RAID Enabled item in the SATA Configuration sub-menu in the

BIOS. See section “4.4.7 Onboard Device Configuration” for details.

Connect the right-angle side

of the SATA signal cable to

the SATA device or you may

connect the right-angle side

of the SATA cable to the

onboard SATA port to avoid

placement conflict with huge

graphics cards.

right angle side

R

M2N-E SLI

M2N-E SLI IDE Connectors

NOTE: Orient the red markings

(usually zigzag) on the ID

ribbon cable to PIN 1.

PRI_IDE

PIN1

SEC_IDE

PIN1

R

M2N-E SLI

M2N-E SLI SATA Connectors

G

ND

RS

AT

A_

TX

P3

RS

AT

A_

TX

N3

G

ND

RS

AT

A_

RX

P3

RS

AT

A_

RX

N3

G

ND

SATA3

G

ND

RS

AT

A_

TX

P4

RS

AT

A_

TX

N4

G

ND

RS

AT

A_

RX

P4

RS

AT

A_

RX

N4

G

ND

SATA4

G

ND

RS

AT

A_

TX

P1

RS

AT

A_

TX

N1

G

ND

RS

AT

A_

RX

P1

RS

AT

A_

RX

N1

G

ND

SATA1

G

ND

RS

AT

A_

TX

P2

RS

AT

A_

TX

N2

G

ND

RS

AT

A_

RX

P2

RS

AT

A_

RX

N2

G

ND

SATA2