General Pump KE Repair Manual - Manual (Page 5)

GENERAL PUMP
A member of the Interpump Group
KE SERIES
Page 5
B) Before reassembly of the side covers, check the seal lips for wear. If replacement is necessary, position
the new ring using the correct tool (#F27904500) as shown in fig. 5.
If the shaft presents diameter wear corresponding to the sealing lip, to avoid the need for griding it’s
possible to position the ring as indicated in fig. 5.
To help the covers fit onto the crankcase, we advise to use 3 screws, M6 x 40, and then finish the
operation with the screws supplied (M6 x 18) as shown in fig. 6.
Ref 300892 Rev.A
06-12