Farm Star HK-201 - Manual (Page 7)

Important Safety Information!
Working with unfamiliar equipment can lead to careless injuries. Read this manual, and the manual for your tractor,
before assembly or operating, to acquaint yourself with the machines. It is the owner’s responsibility, if this equipment
is used by any person other than yourself, is loaned or rented, to make certain that the operator, prior to operating:
1. Reads and understands the operator’s manuals.
2. Is instructed in safe and proper use.
The use of this equipment is subject to certain hazards which cannot be protected against by mechanical
means or product design. All operators of this equipment must read and understand this entire manual, paying
particular attention to safety and operating instructions, prior to using. If there is something in this manual you
do not understand, ask your supervisor, or your dealer, to explain it to you.
Most accidents occur because of neglect or carelessness. Keep all helpers and bystanders twenty-five feet
(25’) from an operating tractor and implement. Only properly trained people should operate this equipment. It
is recommended the tractor be equipped with a Rollover Protection System (ROPS) and a seat belt that is
used. Always stop the tractor, set brake, shut off the tractor engine, remove the tractor key, and lower imple-
ment to the ground before dismounting tractor. Never leave equipment unattended with the tractor running.
Please remember it is important that you read and heed the safety signs on the hitch kit, and the safety rules
set forth. Clean or replace all safety signs if they cannot be clearly read and understood. They are there for
your safety as well as the safety of others. The safe use of this equipment is strictly up to you, the operator.
To the Owner/Operator/Dealer
All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator
who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this
implement to be used with all its safety equipment properly attached to minimize the chance of accidents.
B E F O R E Y O U S TA RT!!
Read the safety messages on the implement and shown in your manual.
Observe the rules of safety and common sense!
1 6
THIS SAFETY ALERT SYMBOL IDENTIFIES IMPORTANT SAFETY WARNING
MESSAGES. CAREFULLY READ EACH WARNING MESSAGE THAT FOLLOWS.
FAILURE TO UNDERSTAND AND OBEY A SAFETY WARNING, OR RECOGNIZE A
SAFETY HAZARD, COULD RESULT IN AN INJURY OR DEATH TO YOU OR OTH-
ERS AROUND YOU. THE OPERATOR IS ULTIMATELY RESPONSIBLE FOR THE
SAFETY OF HIMSELF, AS WELL AS OTHERS, IN THE OPERATING AREA OF THE
EQUIPMENT.
UNDERSTAND SIGNAL WORDS
A signal word – DANGER, WARNING or CAUTION – is used with the
safety-alert symbol. DANGER identifies the most serious hazards.
DANGER and WARNING safety signs are located near the specific
hazard. CAUTION safety signs list general precautions.
The safety-alert symbol is also used in this manual to call attention to
safety messages.
D A N G E R !
W A R N I N G !
C A U T I O N !
REF. PART NO.
NO. NO. DESCRIPTION REQ'D.
1 861210 Main Frame Weldment 1
2 861229 Angle Stop 2
3 861212 Bolting Piece Weldment 2
4 861211 Pull Pin Lock Plate 2
5 861214 Adjusting Link 2
6 861209 Tie Bar 2
7 861213 Top Link Bracket Weldment 1
8 590299 Top Link, Cat. I (AK-513F) 1
9 590002 Top Link Pin, Cat. I (AK-9) 1
10 590006 Linch Pin 7 / 16 ” (AK-14) 1
11 861217 Pipe Spacer 4
12 2504148 Cotter Pin 3 / 8 ” x 2 1 / 2 ” 2
13 2401025 #3 Double Loop Chain, 9 Links 2
14 2501005 Washer 5 / 8 ” Flat 6
15 2502007 Washer 5 / 8 ” Springlock 10
16 2500013 Nut 5 / 8 ” – 11NC Full Hex 10
17 2503048 Bolt 5 / 8 ” – 11NC x 2” Hex Head 6
18 2503060 Bolt 5 / 8 ” – 11NC x 6 1 / 2 ” Hex Head 4
19 2503011 Bolt 3 / 8 ” – 16NC x 1” Hex Head 2
20 2503062 Bolt 1 / 2 ” – 13NC x 1” Hex Head 2
21 2503006 Bolt 3 / 8 ” – 16NC x 1 1 / 2 ” Hex Head 4
22 2501004 Washer 3 / 8 ” Flat 4
23 2502008 Washer 3 / 8 ” Springlock 2
24 2500042 Nut 3 / 8 ” – 16NC Hex Nylock 4
25 2502002 Washer 1 / 2 ” Springlock 2
26 2504015 Cotter Pin 1 / 8 ” x 1 1 / 2 ” 2
NS 101082 Decal – Warning (Pull From Drawbar) 1
HK-201 3PT. ADAPTER KIT REPAIR PARTS
WARNING
Pull from drawbar
or 3-Pt. lower lift
arms only. Failure
to hitch properly
could cause tractor
flip-over, resulting
in serious injury or
death.
101082