Farm Star EM/2 72 - Manual (Page 3)

2
D E L I V E RY C H E C K L I S T
Inspect the mower thoroughly after assembly to be cer-
tain it is set up properly. The following checklist is a
reminder of points to inspect. Check off each item as it is
found satisfactory or after proper adjustment is made.
h Check operator's manual and familiarize the opera-
tor with all sections of it.
h Check that all safety shielding is in place.
h Check all bolts to be sure they are tight or adjusted
properly at hinged locations.
h Check that all cotter pins are properly installed.
h Check PTO driveline. Make sure it is the correct
length to operate mower with intended tractor.
h Check that all lubrication points with grease fittings
have been lubricated.
h Check that blades have been properly installed.
Check all blade bolts.
h Check mower attitude, after mounting on tractor.
h Check that gearbox is properly serviced and seals
are not leaking.
h Check shear bolt for proper grade and installation.
h All safety signs (decals) in place and readable.
h When the cutter is transported on a road or highway
at night or during the day, safety devices should be
used for adequate warning to operators of other
vehicles.
C H E C K L I S T S
I M P O RTA N T !
Gearbox was not filled at factory. It must be serviced before operating. Fill to
proper level with SAE 90 oil. Failure to service will result in damage to gearbox.
P R E - O P E R AT I O N C H E C K L I S T
(OWNER/OPERATOR RESPONSIBILITY)
____ Review and follow safety rules and safety signs on
pages 3 through 17.
____ Check that mower is properly and securely
attached to tractor.
____ Make sure driveline spring-activated locking pin or
locking balls operate freely and are seated firmly in
tractor PTO spline groove.
____ Lubricate all grease fitting locations. Make sure
PTO shaft slip joint is lubricated.
____ Check to be sure gear lube runs out the small
check plug on side of gearbox.
____ Check that all hardware is properly installed.
____ Check to ensure blades are sharp and secure and
cutting edge is positioned to lead in a counter-
clockwise rotation.
____ Check that all shields and guards are properly
installed and in good condition.
____ Check cutting height, front to rear attitude and top
link adjustment.
____ Place tractor PTO and transmission in neutral
before starting engine.
____ Set tractor PTO gear select lever for 540 rpm
operation.
____ Inspect area to be cut and remove stones,
branches or other hard objects that might be
thrown, causing injury or damage.
____ Check that PTO driveline shields are securely
locked and clears the front of the mower frame.
N O T E S :
2 / 39 - FM001 12/6/00 3:26 PM Page 1