Fairbanks 1124-1 Portable Platform Scale - Manual (Page 7)

h. Screw the two (2) pillar rods (#1) into the base in the two
(2) tapped holes provided.
i. Place the pillar (#2) over the pillar rods with the cutouts
facing to the left and right of the platform
j. Insert the beam load rod (#35) down through the pillar,
with the bent hook on top, loose swivel hook on the bottom.
2. Cap and Beam Assembly for 1124 and 1124-1 Models
(Beam Installations):
a. Place the beam support ( #39) over the pillar rods with the
"hook" facing to the right (when facing the scale platform).
b. Place the beam cap (#45) over the pillar rods, with the
beam cap extending to the right.
c. Place washers then 'acorn' nuts (#44) over the pillar rods,
hand tighten only.
d. Locate the loop assembly that will support the beam
assembly from the beam cap.
THIS LOOP MUST
BE INSTALLED CORRECTLY TO ALLOW
THE POISE TO SLIDE TO ZERO.
Orient the
open end of the loop assembly to face the end of the
beam assembly when installing. Refer to the drawing
on page 13.
e. Fit the loop over the pivot on the butt END of the beam.
f. Insert the beam into the cutouts in the pillar, then the
beam tip through the beam lock (#43) so that the beam's
MIDDLE loop (on top) will go OVER the 'hook' on the
beam support (thus hanging from the hook).
g. Put the UPPER end of the beam load rod through the
large END loop on the butt of the beam.
h. From the rear of the scale, locate the BOTTOM end of the
03/13 7 50595 Rev. 6