Direct Lift HR8000 - Manual (Page 19)

TWO COLUMN 8K FLOOR PLATE LIFT CO7589 IN50014 Rev. D 03/2/2010 19
Safety and Operating Instructions
Only authorized personnel are to operate lift
Read operating and safety procedures manual completely before operating lift.
• Properly maintain and inspect lift in accordance to owner’s manual.
• Do not operate a lift that is damaged or in need of repair.
• Allow only authorized personnel in the lift bay.
• Stay clear of Lift when raising or lowering (NO RIDERS)
• Keep hands and feet away from pinch points at all times.
• Never override the Lifts operating and safety controls.
• If a vehicle is suspected of falling, clear area immediately.
• Do not rock vehicle while positioned on lift.
• Always use safety jack stands when removing or installing heavy components.
Vehicle Loading
• Position vehicle for proper weight distribution (center of gravity should be midway between
adapters).
• Swing arms under vehicle to allow adapters to contact at the manufacturer’s recommended pick
up points.
• Use caution before lifting pickup trucks, suv’s and other framed vehicles. The individual axle
weight capacity should not exceed 1/2 of lift capacity.
• Make sure vehicle is neither front nor rear heavy.
• Make sure the lifting pads are in a proper and safe position to support the vehicle. (Ref: Lifting
Points Guide and decal on Main side column for typical arm positioning)
Raising Lift
• Push Up switch to raise lift (make sure arm restraints engage or stop and slightly move arm to
allow gear to mesh) until tires clear floor.
• Stop and check for secure contact on adapters and vehicle weight distribution. If secure raise to
desired height.
• ALWAYS lower the lift into the nearest lock position by pressing the lower lever to relieve the
hydraulic pressure and let the latch set right in a lock position.
• Never work under a lift that is not in the locked position.
Lowering Lift
• Clear all obstacles from under lift and vehicle and ensure only the lift operator is in the lift area.
• Stay clear of lift and raise the lift off the safety locks.
• Pull safety latch releases and press the lower lever to begin descent.
• Unload lift by first completely lowering lift, then swinging arms to drive-thru position before moving
vehicle.
Lift Points Note: