Alamo Versa Series - Manual (Page 137)

OPERATION
Versa 03/09 Operation Section 3-25
© 2009 Alamo Group Inc.
OPERA
T
ION
7.OPERATING THE CONTROL VALVES
ON-OFF Switch (Mower Valve) - To operate the mower, pull the switch while the tractor is running. The push-
pull operator will remain in the ON position PULLED or the OFF position PUSHED until the operator desires
to start or stop the mower. Always start the cutterhead with the tractor at idle.
The operator should not leave his seat with this valve engaged or with the tractor engine
running. Allow approximately 60 seconds for the blades to come to rest after turning the
switch off before dismounting.
OPS-B- 0030_C
Operate the Tractor and/or Implement controls only while properly seated in the Tractor seat
with the seat belt securely fastened around you. Inadvertent movement of the Tractor or
Implement may cause serious injury or death.
(SG-29)